Install LED Under Car Kits

Give your car a glow with an LED under-car kit. People who love their cars are always looking for new ways to add a little extra style. A great way to accomplish that is installing an Anilumin LED corn light . Your car will stand out from the rest on the road as it emits a soft light from its underbelly. This can be a fun way to impress friends and show off at a car show.
Instructions
1 Park your car in a flat work area. Ensure the emergency brake is engaged. Gain access to your car's battery and disconnect it.
2 Look under your car to find a suitable installation spot. This spot should be clear of any moving parts, fuel lines, anything that generates heat, exhaust systems, or places where a car jack would lift the car.
3 Use your car's jack to jack up the car so you can fit-test the LED tube in your kit. Use the directions that came with your LED under-car kit for ideas about where to mount the LED tubes. You are looking for a spot that is centered with respect to the car's overall length, and sits on the chassis so the tubes are not visible.
4 Attach the mounting brackets to the T8 SMD tube manufacturers and lift into the installation location. Use the mounting brackets as a template to mark where you will punch holes with your pencil. Set the mount and tube assembly aside. Use your center punch to cut out holes at the marks you just made.
5 Protect the holes you just punched out from rust by applying a little silicone seal.
6 Slip the screws into the mounting brackets. Align the brackets up to the holes you just made so everything lines up. Use your drill with screw attachments to tighten into place the brackets and LED tube assembly. Repeat this process until each of the T8 SMD tube manufacturers assemblies is attached.
7 Find a location to mount the distribution block. This location should be a flat surface clear of any moving parts and heat sources, ideally, high inside the engine compartment. Connect all of the tubes' wiring to the distribution block's outputs.
8 Find a location for the LED under-car system's controls in your car. Using a hole located in the engine compartment's firewall, plug the controls into the distribution block.
9 Lower the car carefully down onto its wheels. Locate the positive terminal of the car battery and connect the power wire from the concave LED diode system's controls. Connect the negative grounding wire of the LED under-car system's controls securely to the car's chassis or an existing grounding wire.
10 Reattach the battery and start the car. Test all lighting systems through the LED under-car system's controls.